Setting Up A WYSE Terminal

Setting Up A WYSE Terminal

Wyse model:
R10L - User manual is also attached below

Setting up a WYSE Terminal

Go to desktop > connection manager

New connection > select ‘RDP’

Connection

Description - Name of the RDP session (IE: Club Speed)

Host Names = server IP address

Connection display

Resolution: 1024*768

Colors: True

Check:

• Full Screen
• Auto-connect on start up
• Auto-connect after disconnect (For Old Speed Screens ONLY)

Logon Tab

Username = Reg1/POS1/PIT1

Password = Sp33d... (OR designated RDP password)

Domain = clubspeed.local (OR trackname.local for older servers)

Options Tab

Auto-connect to local devices

Check the following boxes:

• Printers
• Serials
• USB

Leave the rest as is!

Click Okay

Click on  Desktop (Bottom-Left corner)

System Setup > Preferences

General Tab

Screen Saver - leave as is

Timer - Set to ‘Disabled’

Change Terminal Name (at bottom) to POS1/Reg1,etc

Click OK

If using a Signature Pad:

System Setup > Peripherals

Select Serial Tab

(some WYSE terminals have more than 1 serial port - ensure it is plugged into the one labeled com1)

Serial port - COM1

Baud Rate = 115200

Click OK

Once this is complete, select your Connection in the Connection Manager, and click Connect! DONE!

Tips and Tricks for Trouble-shooting

Network setup

Desktop > System Setup > Network Setup

Use to see DHCP options, DNS options, etc.

Some hot keys = cntl+alt+up arrow = put in window

Ctl+alt+down arrow = alt+tab in pc

G+power on = factory reset

Related Articles